Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Intake Air Temperature (Iat) Sensor Inspection

Mazda CX-5 Service & Repair Manual / Engine / Control / Intake Air Temperature (Iat) Sensor Inspection

IAT Sensor No.1

Resistance inspection

NOTE:

1. Disconnect the negative battery cable..

2. Disconnect the MAF sensor/IAT sensor No.1 connector.

3. Measure the resistance between MAF sensor/IAT sensor No.1 terminals A and B.


Specification


IAT (°C {°F})

Resistance (Kilohms)

?20 {?4}

13.7—16.6

20 {68}

2.49—2.79

60 {140}

0.622—0.703



IAT Sensor No.2

Resistance inspection

NOTE:

1. Disconnect the negative battery cable..

2. Disconnect the MAP sensor/IAT sensor No.2 connector.

3. Remove the MAP sensor/IAT sensor No.2..

4. Measure the resistance between MAP sensor/IAT sensor No.2 terminals A and B.


Specification


IAT (°C {°F})

Resistance (Kilohms)

0 {32}

Approx. 5.9

20 {68}

2.375—2.625

80 {176}

Approx. 0.323

130 {266}

Approx. 0.0893



Heated Oxygen Sensor (HO2 S)
Purpose/Function Detects the oxygen concentration (theoretical air/fuel ratio) in the exhaust gas as basic information for mainly determining the fuel injection amount and as information ...

Intake Air Temperature (Iat) Sensor
IAT Sensor No.1 Purpose/Function Detects the IAT before it passes through the throttle body as basic information for mainly determining the fuel injection amount. Detects the IAT be ...

Other materials:

Tire Maintenance
Improper or inadequate vehicle maintenance can cause tires to wear abnormally. Here are some important maintenance points: Tire Inflation Pressure Inspect all tire pressure monthly (including the spare) when the tires are cold. Maintain recommended pressures for the best ride, top handling, an ...

Rear Stabilizer Control Link Inspection
1. Remove the rear stabilizer control link.. 2. Inspect for bending or damage. If there is any malfunction, replace the rear stabilizer control link. 3. Rotate the ball joint stud 10 times and shake it side to side 10 times. 4. Measure the ball-joint rotational torque using an Allen wrench ...

Crankshaft Position (CKP) Sensor
Purpose/Function Detects the crankshaft speed as basic information for mainly determining the fuel injection timing and ignition timing. Detects the crankshaft speed and inputs it to the PCM as a CKP signal. Construction Installed on the side of the cylinder block (ri ...

© 2016-2022 Copyright www.mcx5.org