Mazda CX-5 Service & Repair Manual: Intake Air Temperature (Iat) Sensor
IAT Sensor No.1
Purpose/Function
-
Detects the IAT before it passes through the throttle body as basic information for mainly determining the fuel injection amount.
-
Detects the IAT before it passes through the throttle body and inputs it to the PCM as an IAT signal.
Construction
-
Built into the MAF sensor.
-
A cold resistor has been adopted as the detecting element for detecting the IAT.
Operation
-
Inputs the signal, which fluctuates according to the IAT after passing through the air cleaner, to the PCM.
IAT sensor No.1 characteristic
Fail-safe
|
DTC No. |
Fail-safe function |
|
P0112:00 |
|
|
P0113:00 |
|
IAT Sensor No.2
Purpose/Function
-
Detects the IAT (in intake manifold) after it passes through the throttle body as basic information for mainly determining the fuel injection amount.
-
Detects the IAT (in intake manifold) after it passes through the throttle body and inputs it to the PCM as an intake air temperature signal.
Construction
-
Built into the MAP sensor.
-
A cold resistor has been adopted as the detecting element for detecting the IAT.
Operation
-
Inputs the signal, which fluctuates according to the IAT in the intake manifold, to the PCM.
IAT sensor No.2 characteristic
Fail-safe
-
Function not equipped.
Intake Air Temperature (Iat) Sensor Inspection
IAT Sensor No.1
Resistance inspection
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No ...
Intake Manifold Vacuum Inspection
1. Disconnect the evaporative hose No.3 (purge solenoid valve side) and install
the vacuum gauge..
2. Verify that the intake air hoses are installed securely.
3. Warm up the engine.
4. Measure ...
Other materials:
Headliner Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Sunroof seaming welt (with sunroof system).
b. A-pillar trim.
c. Front map light.
d. Sunvisor.
e. Front scuff plate.
f. Rear scuff plate.
g. B-pillar lower trim.
h. Adjust anchor cover.
i. Upper anchor i ...
Discharge Headlight Service Warnings
Discharge Headlight Service Warnings
When replacing a discharge headlight bulb, performing the servicing with
the negative battery cable connected or in a wet work area could result in electrocution.
When replacing a discharge headlight bulb, perform the servicing under the following
...
Seat Weight Sensor Inspection [Two Step Deployment Control System]
CAUTION:
If any of the following work is performed, perform the seat weight sensor
inspection using the M-MDS.
Removal of the passenger-side seat
Loosening and retightening of passenger’s seat fixing bolts
Or, the vehicle is involved in a collision
...
