Mazda CX-5 Service & Repair Manual: Ignition System [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Electrical / Ignition / Ignition System [Skyactiv G 2.0]

Outline

A direct ignition coil for independent ignition control has been adopted.
An ignition coil built-into the ion sensor has been adopted.
An iridium spark plug has been adopted.

Structural View

Structure

Consists of the following parts:

Spark plug	(See SPARK PLUG [SKYACTIV-G 2.0].)
Ignition coil	(See IGNITION COIL [SKYACTIV-G 2.0].)

Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 ...

Spark Plug Inspection [Skyactiv G 2.0]

Specification Spark plug type PE01-18110, PE02-18110 Plug Gap Inspection CAUTION: To avoid possible damage to the tip, do not adjust the plug gap. To prevent damaging t ...

Other materials:

Oil Pressure Switch Inspection
1. Switch the ignition ON (engine off) and verify that the oil pressure warning light is illuminated. 2. Start the engine and verify that the oil pressure warning light turns off. If the oil pressure warning light is not illuminated or remains illuminated, inspect the wiring harness ...

Ignition Coil Inspection [Skyactiv G 2.0]
Ignition Coil Inspection 1. Perform the spark test and identify the malfunctioning cylinder.. 2. Replace the ignition coil of the malfunctioning cylinder with that of a normal cylinder, and perform the spark test again.. If the spark is not normal due to a malfunctioning ignition coil, ...

Differential Oil Temperature Sensor Removal/Installation
WARNING: Hot differential oil may cause severe burns. Do not perform maintenance while differential oil is hot. 1. Disconnect the negative battery cable. 2. Disconnect the differential oil temperature sensor connector. 3. Remove the differential oil temperature sensor. 4. ...