Mazda CX-5 Service & Repair Manual: Ignition Coil [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Electrical / Ignition / Ignition Coil [Skyactiv G 2.0]

Purpose, Function

The ignition coil generates high voltage by electromagnetic induction to discharge the spark plug.

Construction

The ignition coil is installed to the upper part of the spark plug (direct ignition coil).
With the adoption of the direct ignition coil, the ignition system parts have been simplified. As a result, voltage decrease is suppressed and ignition performance for the spark plug is stabilized.
The ignition coil is built into the igniter and ion sensor. For the ion sensor, refer to CONTROL SYSTEM..

Operation

Optimum ignition timing is performed according to the driving conditions by integrating the ignition control function into the PCM.

Fail-safe


DTC	Fail-safe
P0300:00	Limits the intake air amount.
P0301:00 P0302:00 P0303:00 P0304:00	Stops the fuel injection to the misfiring cylinder. Limits the intake air amount.

DTC

Fail-safe

P0300:00

Limits the intake air amount.

P0301:00

P0302:00

P0303:00

P0304:00

Stops the fuel injection to the misfiring cylinder.
Limits the intake air amount.

Ignition Coil Inspection [Skyactiv G 2.0]

Ignition Coil Inspection 1. Perform the spark test and identify the malfunctioning cylinder.. 2. Replace the ignition coil of the malfunctioning cylinder with that of a normal cylinder, and perfo ...

Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 ...

Other materials:

Oil Strainer
Purpose, Function The oil strainer suctions the engine oil in the oil pan using the oil pump vacuum. The engine oil is filtered by the internal filter at that time. Construction The oil strainer is installed on the suction port of the oil pump. The oil strain ...

General Procedures (Steering)
WARNING: Always inspect the steering component carefully for any shock or impact which may have occurred during a collision or servicing operation. If a damaged part or a part suspected of being damaged is used, it could result in an unexpected accident due to the steering mechanism ...

Door Lock Switch Inspection
Driver's Side 1. Disconnect the negative battery cable.. 2. Remove the door lock switch.. 3. Verify that the continuity is as indicated in the table. If the continuity is not as indicated in the table, replace the door lock switch. Passenger's Side 1. Disconnec ...