Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Electrical / Ignition / Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

1. Disconnect the negative battery cable..

2. Remove the plug hole plate..

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.



1

Connector

2

Ignition coil


Ignition Coil [Skyactiv G 2.0]
Purpose, Function The ignition coil generates high voltage by electromagnetic induction to discharge the spark plug. Construction The ignition coil is installed to the upper par ...

Ignition System [Skyactiv G 2.0]
Outline A direct ignition coil for independent ignition control has been adopted. An ignition coil built-into the ion sensor has been adopted. An iridium spark plug has been ado ...

Other materials:

Seat Weight Sensor Calibration [Two Step Deployment Control System]
CAUTION: If any of the following work is performed, perform the seat weight sensor calibration using the M-MDS. Replacement with a new seat weight sensor Replacement with a new seat weight sensor control module Replacement with new passenger-side seat pa ...

Aerodynamic
Purpose/Function For improved aerodynamics, under covers are installed to the under-surface of the vehicle. Construction The vehicle is equipped with the following (3) under covers. Front under cover No.1 Front under cover No.2 Floor under co ...

PCM
Purpose/Function High-level driveability and lower fuel consumption have been realized by controlling the appropriate engine conditions (fuel injection/ignition timing) according to operation conditions. Controls each output part based on the signal from each input part. ...

© 2016-2022 Copyright www.mcx5.org