Mazda CX-5 Service & Repair Manual: Horn Inspection
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Remove the horn..
4. Apply battery positive voltage to horn terminal A, and connect the horn retaining bolt to ground as shown in the figure, and then verify that the horn sounds.
-
If the horn does not sound, replace the horn.
Horn
Purpose, Function
The horn sounds according to the horn switch operation.
Construction
Installed to the inside of the front grille.
The diaphragm is vibrated to apply vibra ...
Horn Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Disconnect the connector.
4. Remove the bolt.
5. Remove the horn.
6. Install in the reverse order of removal. ...
Other materials:
Vacuum Pump [Skyactiv G 2.0]
Purpose, Function
Ensures vacuum required for braking force to compensate for the decrease
in intake manifold vacuum applied to the power brake unit caused by the retard
intake valve closing.
Construction
The vacuum pump is installed to the rear housing.
For s ...
Sunvisors
When you need a sunvisor, lower it for use in front or swing it to the side.
Side Extension Sunvisors
The visor extender extends the sunvisor's range of sun shading.
To use, pull it out.
CAUTION
When moving the sunvisor, retract the visor extender to its original position.
Otherwise, ...
Accelerator Pedal Position (App) Sensor Inspection
Voltage Inspection
NOTE:
Because the APP sensor is integrated in the accelerator pedal, replacing
the APP sensor includes replacement of the accelerator pedal.
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine off or on).
3. Verify that the APP sensor output ...
