Mazda CX-5 Service & Repair Manual: Horn
- Horn
- Horn Inspection
- Horn Removal/Installation
- Theft Deterrent Horn Inspection
- Theft Deterrent Horn Removal/Installation
Windshield Removal
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Windshield wiper arm and blade.
b. Cowl grille.
c. Rain sensor (with auto light/wiper system).
d. Auto-dimming mi ...
Horn
Purpose, Function
The horn sounds according to the horn switch operation.
Construction
Installed to the inside of the front grille.
The diaphragm is vibrated to apply vibra ...
Other materials:
Windshield Wiper And Washer Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Column cover.
b. Wiper and washer switch.
3. Use a tester to measure and verify that the continuity between the windshield
wiper and washer switch terminals is as indicated in the table.
If the continu ...
Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax
EL]
Purpose/Function
The turbine/input shaft speed sensor detects the rotation speed of the input
shaft (low clutch drum).
The output shaft speed sensor detects the rotation speed of the output shaft
(primary gear).
The turbine/input shaft speed sensor and output shaft speed ...
Relay And Fuse Block Middle Cover Disassembly/Assembly
1. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
2. While pressing the relay and fuse block middle cover tab in the direction
of arrow (1) shown in the figure, pull out the bracket in the direction of arrow
(2) to detach the relay a ...
