Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Hood Latch Switch

Purpose

Function

Construction

Operation

Hood close (latch) operation

1. When the hood is closed, the hood lock striker enters the latch lever groove.

2. When the hood is then further closed, the latch lever is pressed by the hood lock striker and rotates.

3. When the hood is completely closed, the latch lever is in a latched condition and presses the hood latch switch which turns the switch on.

Hood open (unlatch) operation

1. When the hood release lever is pulled, the hood opens and the latch lever is in an unlatched condition, and the hood latch switch turns off.

Fail-safe

Hood Latch And Release Lever Removal/Installation
Hood Latch 1. Open the hood. 2. Disconnect the negative battery cable.. 3. Remove the front bumper.. 4. Insert a tape-wrapped flathead screwdriver into the position shown in the figure. ...

Hood Latch Switch Inspection
1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Disconnect the hood latch switch connector.. 4. Verify that the continuity is as indicated in the table. NOTE: ...

Other materials:

Units
Electric current A (ampere) Electric power W (watt) Electric resistance ohm Electric voltage V (volt) Length mm (millimeter) in (inch) ...

Installing Child-Restraint Systems
Accident statistics reveal that a child is safer in the rear seat. The front passenger's seat is clearly the worst choice for any child under 12, and with rear-facing childrestraint systems it is clearly unsafe due to air bags. NOTE Even if your vehicle is equipped with front passenger sea ...

Engine Coolant Protection Inspection
1. Measure the engine coolant temperature and specific gravity using a thermometer and a hydrometer. CAUTION: Use engine coolant at a concentration that meets the environmental conditions in which the vehicle is driven, otherwise engine damage could occur. The engine has alumi ...

© 2016-2024 Copyright www.mcx5.org