Mazda CX-5 Service & Repair Manual: Hood Latch And Release Lever Removal/Installation
Hood Latch
1. Open the hood.
2. Disconnect the negative battery cable..
3. Remove the front bumper..
4. Insert a tape-wrapped flathead screwdriver into the position shown in the figure.
5. Move the tape-wrapped flathead screwdriver in the direction of arrow (1) shown in the figure to press the hood latch protector tab, and lift the tab up in the direction of arrow (2) and detach its tab from the fuse box.
6. Detach all the hood latch protector tabs from the hood latch and remove the hood latch protector.
7. While pressing the tabs of the clip in the direction of arrow (1) shown in the figure, press it in the direction of arrow (2) to detach the connector tabs from the body.
8. Remove the connector antenna from the body.
9. Disconnect the connector.
10. Disconnect the hood release cable.
11. Remove the bolts.
12. Remove the hood latch.
13. Install in the reverse order of removal.
14. Adjust the hood..
Hood Release Lever
1. While pulling the hood release lever, insert a tape-wrapped flathead screwdriver into the position shown in the figure.
2. Move the tape-wrapped flathead screwdriver in the direction of arrow (1) shown in the figure to press the tab, and pull the hood release lever in the direction of arrow (2) to detach it from the lower panel.
CAUTION:
-
Remove the hood release lever while being careful not to damage the hood release cable with the flathead screwdriver.
3. Pull the hood release lever to remove it from the lower panel.
4. Disconnect the hood release cable from the hood release lever.
5. Install in the reverse order of removal.
Hood Disassembly/Assembly
1. Disassemble in the order indicated in the table.
1
Fastener
2
Hood insulator
3
Shroud seaming welt
...
Hood Latch Switch
Purpose
Detects the open/closed condition of the hood.
Function
The hood latch switch is utilized in the theft-deterrent system control.
For the theft-deterrent system ...
Other materials:
Blind Spot Monitoring (BSM) System
Blind Spot Monitoring (BSM) System
The Blind Spot Monitoring (BSM) system is designed to assist the driver by monitoring
blind spots on both sides of the vehicle to the rear in certain situations such
as when changing lanes on roads and freeways.
The BSM system monitors the detection areas on ...
Ion Sensor
Purpose/Function
Detects ion generation in the combustion chamber for detecting pre-ignition.
Detects ions which occur due to fuel combustion as current by applying bias
voltage to the spark plug, which is amplified in the ignition coil internal
circuit and input to the PCM.
...
Auto Leveling Sensor
Purpose
Detects the vehicle height and outputs it to the AFS control module.
Function
Changes the detected vehicle height into a voltage value and outputs it to
the AFS control module.
Construction
Installed to the rear cross member.
Consists of link No. 1 ...