Mazda CX-5 Service & Repair Manual: Hood Disassembly/Assembly
1. Disassemble in the order indicated in the table.
|
1 |
Fastener |
|
2 |
Hood insulator |
|
3 |
Shroud seaming welt |
|
4 |
Weather strip parting seal |
|
5 |
Hood component |
2. Assemble in the reverse order of disassembly.
Hood Adjustment
Height Difference Adjustment
1. Verify that the height difference between the hood and the body is within
the specification.
Standard clearance
a: 2.7—6.9 mm {0.11—0.27 in}
...
Hood Latch And Release Lever Removal/Installation
Hood Latch
1. Open the hood.
2. Disconnect the negative battery cable..
3. Remove the front bumper..
4. Insert a tape-wrapped flathead screwdriver into the position shown in the
figure.
...
Other materials:
Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)
Follow Schedule 1 if the vehicle is operated mainly where none of the following
conditions apply.
• Repeated short-distance driving
• Driving in dusty conditions
• Driving with extended use of brakes
• Driving in areas where salt or other corrosive
materials are used
• Driving on ...
Awd Control Module Removal/Installation
CAUTION:
When performing configuration, it is necessary to read the coupling component
calibration data from the AWD control module before replacing it. Connect the
M-MDS to the vehicle and perform vehicle identification before removing the
AWD control module. The coupling component ...
Front Brake (Disc) Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, add brake fluid, bleed the air, and inspect for fluid
leakage..
4. Depress the brake pedal a few times, rotate the wheel by hand, and verify
that the brake does not drag.
...
