Height Difference Adjustment
1. Verify that the height difference between the hood and the body is within the specification.
a: 2.7—6.9 mm {0.11—0.27 in}
b: 4.1—8.0 mm {0.17—0.31 in}
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Front over fender.
b. Front bumper.
c. Front combination light.
d. Front bumper slider.
e. Front fender panel.
4. Loosen bolts and adjust the hood.
5. Tighten bolts..
6. Install the following parts:
a. Front fender panel.
b. Front bumper slider.
c. Front combination light.
d. Front bumper.
e. Front over fender.
7. Connect the negative battery cable..
Gap Adjustment
1. Verify that the gap between the hood and the body is within the specification.
a: -1.2—1.2 mm {-0.047—0.047 in}
2. Turn the stopper rubber to adjust the height of the hood.
Air Bag System Service Cautions [Standard Deployment Control System]
Air Bag System Component Disassembly
Disassembling the air bag system components could cause it to not operate
(deploy) normally. Never disassemble any air bag system components.
Air Bag Module, Pre-tensioner Seat Belt Handling
Oil, grease, or water on the air bag modules ...
Starter Interlock Switch Removal/Installation [C66 M R]
1. Disconnect the negative battery cable..
2. Disconnect the starter interlock switch connector.
3. Remove the starter interlock using the following procedure:
a. Detach hook A in the direction of the arrow shown in the figure.
b. Slide the starter interlock switch in the direction of th ...
Interior Equipment (View A)
1 Door-lock knob
2 TCS OFF switch
3 Tire pressure monitoring system set switch
4 Turn and lane-change signal
5 Lighting control
6 Instrument cluster
7 Dashboard illumination knob
8 Wiper and washer lever
9 Push button start
10 AFS OFF switch
11 BSM OFF switch
12 Outside mirror ...