Mazda CX-5 Service & Repair Manual: Headlight Leveling Actuator
Purpose, Function
-
The headlight leveling actuator drives the motor based on the target optical axis voltage, which is input from the AFS control module, to change the optical axis of the headlights.
Construction
-
Built into the front combination lights.
-
Consists of a motor which expands/retracts the shaft, a shaft, and a microcomputer which calculates the shaft expansion/contraction amount.
Operation
1. When the ignition is switched on (engine on or off), the auto leveling sensor inputs a vehicle height signal to the AFS control module.
2. When the headlights (LO) turn on, the AFS control module calculates the amount of change in vehicle height * based on the vehicle height signal.
3. If the operation conditions are met, the AFS control module calculates a target optical axis based on the calculated change in vehicle height *. For details on the operation conditions, refer to the headlight auto leveling system..
4. The AFS control module outputs the calculated target optical axis signal to the headlight leveling actuator.
5. The headlight leveling actuator drives the motor based on the input target optical axis.
6. When the motor is driven, the shaft moves back and forth and the reflector shifts to move the optical axis.
* The amount of change in vehicle height is the calculated 1 s average value of the detected vehicle body angle which the AFS control module detects every 0.1 s.
Fail-safe
-
Function not equipped.
Headlight High Beam Indicator Light
Purpose
Notifies the user that the headlights (HI) are illuminated.
Function
Illuminates when the headlight (HI) or parking illumination conditions are
met.
Construction
...
High Mount Brake Light
Purpose
The high-mount brake light signals vehicles to the rear that the vehicle
is stopped.
Function
The high-mount brake light illuminates in conjunction with the operation
...
Other materials:
Rear Wiper Arm And Blade Removal/Installation
Rear Wiper Arm
1. Pull the cap in the direction of the arrows (1) shown in the figure and remove
it in the direction of the arrow (2) with tabs A, B released.
2. Remove the nut with the rear wiper arm and blade pressed.
3. Raise the rear wiper arm and detach it from the serrated conne ...
Wiper Bracket Removal [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
Side Turn Light
Purpose
The side turn lights are used to signal vehicles/people at the side of the
vehicle that the vehicle is going to make a right or left turn.
Function
The side turn lights flash according to the operation of the turn or the
hazard switch.
Construction
Side ...
