NOTE:
Perform headlight aiming if any of the following work is performed.
Front combination light replacement
Work that can affect vehicle height such as suspension replacement or removal/installation.
1. Empty the vehicle by having all occupants leave the vehicle and remove all the cargo except for the spare tire, jack and tools equipped on the vehicle.
2. Adjust the air pressure of each tire to the specified value..
3. Move the vehicle to level ground.
4. Make a screen shown in the figure using double-weight, white paper.
5. Line up the vehicle with the wall so that the distance to the headlights is 3 m {9.8 ft}
from the wall.
6. Measure the height at the center point of the headlight.
NOTE:
Measure the height at the center point of the headlight in which the aiming is being adjusted because the vehicle height differs depending on vehicle conditions.
7. Align the center of the headlight with the center of the screen.
8. Set a partition in front of the headlight which is not being adjusted to block the light.
9. Start the engine and charge the battery.
10. Turn on the headlight low beams.
11. Verify that the elbow point of the headlight is at the position indicated on the adjustment screen.
If the elbow point of the headlight is not at the position indicated on the adjustment screen, perform the following adjustment.
a. Rotate the adjustment screw to adjust the headlight.
Neutral Switch
Purpose/Function
Detects the neutral position of the shift lever.
Construction
Installed to the manual transaxle.
An ON/OFF type switch has been adopted.
Operation
Inputs the neutral switch on/off signal to the PCM.
The contact point is on ...
Engine SST
1: Mazda SST number
2: Global SST number
Example
1:49 UN20 5072
2:205–072
Holder
1:–
2:AKS042808
Adapter
1: 49 UN20 5072
2: 205–072
Holder
1: 49 B011 105
2: –
...
Electrical System
Electrical Parts
Battery cable
Before disconnecting connectors or removing electrical parts, disconnect
the negative battery cable.
Wiring Harness
To remove the wiring harness from the clip in the engine room, pry up the
hook of the clip using a flathead screwdriver. ...