Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: General Procedures (Front And Rear Axles)

Mazda CX-5 Service & Repair Manual / Drivetrain / Driveline / General Procedures (Front And Rear Axles)

Wheel and Tire Installation

1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque.


Suspension Links Removal/Installation

1. For the joint sections with rubber bushings, raise the vehicle using a lift, and then temporarily tighten the installation bolts and nuts. Lower the vehicle to the ground and tighten them to the specified tightening torque.

Connector Disconnection

1. Disconnect the negative battery cable before performing any work that requires handling of connectors..

Headlight Auto Leveling System Initialization (Vehicle with discharge headlight system)

1. Initialize the auto leveling sensor, when performing the following services.

Electronic AWD Control System Parts

1. After servicing the electronic AWD control system parts, verify that no DTC has been stored. Clear any DTCs remaining in the memory.

Driveline/Axle SST
Front and Rear Axle 49 T028 3A0 Ball joint puller set 49 T028 301 Dust boot installer 49 U034 204 Dust boot installer ...

4WD
...

Other materials:

Cooling Fan Relay
Purpose, Function The cooling fan relay operates by receiving the signal from the PCM to supply power to the cooling fan motor. Construction The cooling fan relay is installed on the relay and fuse block. Operation The contact point is on when the battery vo ...

Manual Transaxle Oil Replacement [C66 M R]
1. Park the vehicle on level ground. 2. Remove the front under cover No.2.. 3. Remove the drain plug and gasket, and drain the manual transaxle oil. 4. Install a new gasket and the drain plug. Tightening torque 39—59 N·m {4.0—6.0 kgf·m, 29—43 ft·lbf} 5. Remove the ...

Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
Description BSM indicator light does not flash while under BSM indicator light-flashing conditions (with combination switch operation (turn signal switch)) The BSM indicator light does not flash or illuminate continuously, but the cond ...

© 2016-2024 Copyright www.mcx5.org