Mazda CX-5 Service & Repair Manual: General
- Engine Transaxle Integration Control [Fw6 A EL, Fw6 Ax EL]
- Output Gear [Fw6 A EL, Fw6 Ax EL]
- Shift Lever [C66 M R]
- Shift Point Control (Automatic Shift Control) [Fw6 A EL, Fw6 Ax EL]
- Shift Point Control (Manual Shift Control) [Fw6 A EL, Fw6 Ax EL]
- Transaxle Fluid Temperature (Tft) Sensor [Fw6 A EL, Fw6 Ax EL]
- Transaxle Range Sensor [Fw6 A EL, Fw6 Ax EL]
Engine Transaxle Integration Control [Fw6 A EL, Fw6 Ax EL]
Outline
The TCM controls engine output torque and reduces transaxle output shaft
torque fluctuation during auto shifting, and reduces shock occurring from the
vehicle during shifting.
...
Other materials:
Engine Oil Level Inspection
1. Position the vehicle on level ground.
2. Warm up the engine.
3. Stop the engine and allow at least 5 min before continuing.
4. Remove the dipstick, wipe it cleanly, and reinstall it fully.
5. Remove the dipstick and verify that the oil level is between the F and L marks
on the dipstick. ...
Front Drive Shaft Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor connector (axle side) ...
Rear Pillar (Outer) Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
