Mazda CX-5 Service & Repair Manual: General

Wipers, Washers

...

Rear Wiper And Washer Switch Inspection

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Column cover. b. Wiper and washer switch. 3. Use a tester to measure and verify that the continuity between the rea ...

Other materials:

Rear Fender Panel Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

Climate Control Unit Inspection [Full Auto Air Conditioner]
1. Remove the climate control unit with the connector connected.. 2. Switch the ignition ON (engine off or on). 3. Connect the negative (-) lead of the tester to body ground. 4. By inserting the positive (+) lead of the tester into each climate control unit terminal, measure the voltage acco ...

Audio Amplifier Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (RH). b. Front side trim (RH). 3. Remove the bolts. 4. Lift up the audio amplifier in the direction of the arrow (1) shown in the figure, pull it in the direction of the arrow (2) shown in ...