Mazda CX-5 Service & Repair Manual: General
- Auto Leveling Sensor
- Auto Leveling Sensor Inspection
- Auto Leveling Sensor Removal/Installation
- Auto Light Off System
- Auto Light System
- Cargo Compartment Light
- Cargo Compartment Light Bulb Removal/Installation
- Cargo Compartment Light Inspection
- Cargo Compartment Light Removal/Installation
- Lighting System Personalization
- Lighting System Personalization Features Setting Procedure
- Lighting Systems
- Parking/Front Turn Light Bulb Removal/Installation
- Rear Turn Light Bulb Removal/Installation
- Side Turn Light
- Side Turn Light Inspection
- Side Turn Light Removal/Installation
- Turn Light System
- Vanity Mirror Illumination Inspection
Lighting & Horn
...
Auto Leveling Sensor
Purpose
Detects the vehicle height and outputs it to the AFS control module.
Function
Changes the detected vehicle height into a voltage value and outputs it to
the AFS control ...
Other materials:
Front Oil Seal Replacement
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
1. Remove the front under cover No.2..
2. Remove the splash shield..
3. Remove the drive belt..
4. Remove in the order indicated in the table.
5. Install in the reve ...
B Pillar Lower Trim Removal/Installation
1. Remove the front scuff plate..
2. Remove the rear scuff plate..
3. Partially peel back the seaming welt.
4. Take the shaded area shown in the figure, and pull the B-pillar lower trim
in the direction of the arrow in the order of (1), (2) while detaching hooks A,
pins B.
5. Take th ...
Roof Carrier Bracket Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Sunroof seaming welt (with sunroof system).
b. A-pillar trim.
c. Front map light.
d. Sunvisor.
e. Front scuff plate.
f. Rear scuff plate.
g. B-pillar lower trim.
h. Adjust anchor cover.
i. Upper anchor i ...
