Mazda CX-5 Service & Repair Manual: General

Body Interior

...

A Pillar Trim Removal/Installation

1. Partially peel back the seaming welt. 2. Take the shaded area shown in the figure, and pull the A-pillar trim in the direction of the arrow (1) while detaching clip A, clips B. 3. Cut the ...

Other materials:

Cooling Fan Motor Inspection
Part Inspection 1. Verify that the battery is fully charged.. 2. Disconnect the cooling fan motor connector (2 terminals). 3. Install a tester and battery to the cooling fan motor connector (2 terminals) as shown in the figure. 4. Verify that each cooling fan motors operate smoothly at ...

Oil Pressure Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes. ...

Reduction Gear
Purpose/ Function The reduction gear transmits the rotation input from the EPS motor, decreasing the rotation speed and increasing the torque simultaneously. Construction The reduction gear consists of the worm wheel located on the steering column main shaft and the worm sh ...