Mazda CX-5 Service & Repair Manual: Fuel Shut Off Valve Inspection
U.S.A. And CANADA
NOTE:
-
The fuel shut-off valve cannot be removed and inspected as it is built into the fuel tank.
1. Perform the fuel tank inspection..
-
If there is any malfunction, replace the fuel tank.
Fuel Pump Unit
Purpose, Function
Supplies fuel in the fuel tank to the high pressure fuel pump.
Based on the control signal from the PCM, the fuel pump operates by the operation
of the fuel pump re ...
Fuel Shut Off Valve
U.S.A. And CANADA
Purpose, function
Prevents fuel from flowing to the charcoal canister during tight turns or
vehicle rollover.
Releases evaporative gas to the charcoal canister.
...
Other materials:
Cooling System Cap
Purpose, Function
The cooling system cap maintains appropriate pressure in the engine coolant
passage. In addition, cooling efficiency has been improved by increasing the
engine coolant boiling point.
Construction
The cooling system cap is installed to the upper part of the ...
D Pillar Trim Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
3. Take the shaded area shown in the figure, and remove the D-pillar trim in
the direction of the arrow in the order of (1), (2), (3) wh ...
PID/Data Monitor Inspection [Instrument Cluster]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “IC”.
3. Select the applicable PID from the PID table.
4. Verify the PID dat ...
