Mazda CX-5 Service & Repair Manual: Fuel Shut Off Valve
U.S.A. And CANADA
Purpose, function
-
Prevents fuel from flowing to the charcoal canister during tight turns or vehicle rollover.
-
Releases evaporative gas to the charcoal canister.
-
While refueling, the fuel shut-off valve closes to prevent a fuel overflow.
Construction
-
The fuel shut-off valve is built into the fuel tank.
-
The fuel shut-off valve consists of float and spring.
Operation
-
While refueling or due to fuel sloshing, the float is flooded with fuel and the floating force causes the valve to close. Also, during a vehicle rollover, the valve closes due to balance between the float gravity and spring.
Fuel Shut Off Valve Inspection
U.S.A. And CANADA
NOTE:
The fuel shut-off valve cannot be removed and inspected as it is built into
the fuel tank.
1. Perform the fuel tank inspection..
If there is any malfu ...
Fuel System
Purpose, Outline
A multiple hole type fuel injector has been adopted which provides higher
fuel injection accuracy for improved fuel efficiency and output.
Piston movement-compressio ...
Other materials:
Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air
Conditioner]
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (driver-side).
b. Front side trim (driver-side).
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX).
f. Front console box.
g. Shift panel.
h. Upper panel.
i. Rear console. ...
Blind Spot Monitoring (Bsm) Control Module Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the rear combination light..
3. Remove the rear bumper..
4. Disconnect the connector.
5. Remove the nuts.
6. Remove the BSM control module.
7. Install in the reverse order of removal.
8. Perform the BSM radar test..
CAUTION:
...
PCM Configuration (Using As Built Data)
NOTE:
If the configuration is performed using As-Built data, the set value of the
personalization function is reset to the initial value (condition when shipped
from factory). Verify the set value with the customer and perform the personalization
function setting after performing th ...
