Mazda CX-5 Service & Repair Manual: Fuel Pump Unit Disassembly/Assembly
WARNING:
-
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring to “BEFORE SERVICE PRECAUTION”.
-
A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before draining fuel, make sure to discharge static electricity by touching the vehicle body.
CAUTION:
-
Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.
1. Complete the “BEFORE SERVICE PRECAUTION”..
2. Using the following procedure:
CAUTION:
-
Because the fuel surface is higher than the fuel pump unit installation surface, if the set plate is removed, it may result in fuel leakage. If the fuel gauge level indicates 1/2 or more, refer to the fuel draining procedure and drain 20 liters of fuel.
-
Fuel gauge indicates 1/2 or more
-
Drain the fuel..
-
Fuel gauge indicates less than 1/2
-
Disconnect the negative battery cable..
3. Remove the following part:
-
6:4 split type
-
Remove the rear seat cushion..
-
4:2:4 split type
-
Set the rear seat aside as shown in the figure..
4. Remove the fuel pump unit..
5. Disassemble in the order indicated in the table.
6. Assemble in the reverse order of disassembly.
7. Install in the reverse order of removal.
8. Complete the “AFTER SERVICE PRECAUTION”..
2WD
|
1 |
Fuel gauge sender unit |
|
2 |
Fuel filter (low-pressure) |
|
3 |
Pressure regulator |
|
4 |
Fuel pump |
|
5 |
Fuel filter (high-pressure) |
AWD
|
1 |
Fuel gauge sender unit |
|
2 |
Fuel filter (low-pressure) |
|
3 |
Pressure regulator |
|
4 |
Fuel pump |
|
5 |
Fuel filter (high-pressure) |
Fuel Pump Control
Outline
By switching the fuel pump discharge amount, reduced power consumption and
improved fuel economy have been realized.
The PCM determines the optimum fuel pump drive force acco ...
Fuel Pump Unit Inspection
Continuity Inspection
1. Disconnect the negative battery cable..
2. Disconnect the fuel pump unit connector.
3. Inspect for continuity between fuel pump unit terminals B—D.
If there ...
Other materials:
Rear Wiper System
Outline
Equipped with continuous, auto-stop, intermittent wiper, and synchronized
washer and wiper operation.
The front body control module (FBCM) performs rear wiper and washer system
fail-safe..
Structural View
System Wiring Diagram
Operation
Continuous operat ...
Starter Relay [Skyactiv G 2.0]
Purpose, Function
The starter relay supplies power to the starter by receiving the signal from
the PCM.
Construction
The starter relay is installed to the relay and fuse block.
Operation
The contact point is on when the voltage is supplied to the coil based on
...
Oil Control Valve (OCV) Inspection
Coil Resistance Inspection
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Disconnect the OCV connector.
4. Measure the resistance between terminals A and B using an ohmmeter.
OCV coil resistance
6.9—7.5 ohms [20°C {68°F}]
If not as ...
