Mazda CX-5 Service & Repair Manual: Fuel Pump Control Module Inspection
1. Perform the KOEO self-test..
2. Verify that a fuel pump control module related DTC is detected..
-
If DTCs are detected, repair the malfunctioning part according to the applicable DTC troubleshooting..
-
If a DTC is not detected, go to the next step.
3. Inspect the following:
-
Fuel pump control module damage
-
Fuel pump control module connector damage or corrosion
-
If there is any malfunction, repair or replace the malfunctioning part.
Fuel Line Pressure Inspection
WARNING:
Fuel line spills and leakage from the pressurized fuel system are dangerous.
Fuel can ignite and cause serious injury or death and damage. To prevent this,
complete the followin ...
Fuel Pump Control Module Removal/Installation
1. Disconnect the negative battery cable..
2. Tip the rear seat (LH).
3. Disconnect the clip connected to trunk board.
4. Disconnect the fuel pump control module connector.
5. Remove the fuel ...
Other materials:
Front Body Straight Line Dimensions (1) [Dimensions]
Point symbol
Designation
Hole diameter or bolt or nut size mm {in}
A
Cowl panel installation hole
?5 {0.2}
B
Wiper bracket datum hole
?7 {0.3}
C
...
Charging System Warning Light
Purpose, Function
Warns the driver of a charging system malfunction.
Construction
The charging system warning light is built into the instrument cluster..
Operation
Illuminates when a malfunction occurs in the charging system and DTCs is
stored in the PCM.
...
DSC HU/CM Inspection
1. Disconnect the DSC HU/CM connector..
2. Connect the negative battery cable..
3. Attach the tester lead to the DSC HU/CM wiring harness-side connector and
inspect voltage, continuity, or resistance according to the standard (reference)
on the table.
Standard (Reference)
...
