Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Fuel Line Pressure Inspection

Mazda CX-5 Service & Repair Manual / Engine / Fuel / Fuel Line Pressure Inspection

WARNING:

CAUTION:

1. Complete the “BEFORE SERVICE PRECAUTION”..

2. Disconnect the negative battery cable..

3. Disconnect the quick release connector as shown in the figure..


4. Turn the lever of the SST

parallel to the hose as shown in the figure.


5. Insert the SST

quick release connector into the fuel pipe until a click is heard.

6. Verify that the quick release connector is firmly connected by pulling it by hand.

7. Start the fuel pump using the following procedure.

8. Operate the fuel pump for 10 s

.

9. Measure the fuel line pressure.

10. Stop the fuel pump using the following procedure.

11. Measure the fuel hold pressure after 5 min

.

12. Complete the “BEFORE SERVICE PRECAUTION”..

13. Disconnect the SST

.

14. Connect the quick release connector..

15. Complete the “AFTER SERVICE PRECAUTION”..

Fuel Injector
Purpose, Function Promotes atomization of fuel by injecting it from the multiple holes. Injects fuel according to the control signal from the PCM. Construction The fuel inj ...

Fuel Pump Control Module Inspection
1. Perform the KOEO self-test.. 2. Verify that a fuel pump control module related DTC is detected.. If DTCs are detected, repair the malfunctioning part according to the applicable DTC tr ...

Other materials:

Refrigerant Pressure Sensor Inspection [Full Auto Air Conditioner]
1. Install the manifold gauge. 2. Verify the high-pressure side reading of the manifold gauge. 3. Measure the terminal voltage at PCM terminal 2BB, 2AX and 2AJ 4. Using the graph below, measure and verify the terminal voltages at 2AX. 5. Follow the PCM inspection when measuring the other te ...

Hill Launch Assist (Hla)
Purpose/Function The hill launch assist (HLA) is a function which assists the driver in accelerating the vehicle on a slope by activating the traction control solenoid valve in the DSC HU/CM when the vehicle begins accelerating on a slope, and maintaining/reducing brake fluid pressur ...

Rear Bumper Disassembly/Assembly
1. Disassemble in the order indicated in the table. 1 Screw 2 Reflector 3 Rear bumper face 2. Assemble in the reverse order of disassembly. ...

© 2016-2024 Copyright www.mcx5.org