1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (LH).
b. Front seat (LH).
c. Rear scuff plate.
d. B-pillar lower trim (LH).
e. Rear seat (4:2:4 split type).
f. Rear seat cushion (6:4 split type).
g. Rear seat back (6:4 split type).
h. D-pillar trim (LH).
i. C-pillar trim (LH).
j. Trunk end trim.
k. Trunk side trim (LH).
l. Fuel-filler lid opener.
m. Fuel-filler lid opener lever.
3. Remove the fuel-filler lid opener cable from clip A.
4. Remove the fuel-filler lid opener cable from clips B, C, and D.
5. Remove the fuel-filler lid opener cable from clips E.
6. Pull the fuel-filler lid opener cable from the crossmember and the seat bracket.
7. Install in the reverse order of removal.
Rear Drive Shaft
Purpose, Function
Engine noise and vibration have been reduced due to adoption of a bell joint
on the wheel side of the constant velocity joint.
A low noise and vibration double offset joint with low slide resistance has
been adopted for the differential side of the constant vel ...
Fuel Pump Control
Outline
By switching the fuel pump discharge amount, reduced power consumption and
improved fuel economy have been realized.
The PCM determines the optimum fuel pump drive force according to the engine
operation conditions, and sends the fuel pump drive signal to the fuel pump
...
Coupling Component Removal/Installation
WARNING:
When replacing the coupling component, read the special character string
before installing a new coupling component and write it to the AWD control module
after replacement. The special character string is indicated in the two locations
shown in the figure.
1. D ...