Mazda CX-5 Service & Repair Manual: Fuel Filler Lid Opener And Lever Removal/Installation
Fuel-filler Lid Opener
1. Open the fuel-filler lid.
2. Remove the nut.
3. Remove the service hole cover on the trunk side trim.
4. While pressing the tabs of the stopper bracket in the direction of arrow (1) shown in the figure, press it in the direction of arrow (2) to detach it from the body.
5. Detach all the stopper bracket tabs from the body and remove the stopper bracket.
6. Remove the fuel-filler lid opener in the direction of the arrow.
7. Disconnect the fuel-filler lid opener cable from the fuel-filler lid opener.
8. Install in the reverse order of removal.
Fuel-filler Lid Opener Lever
1. Remove the front scuff plate. (Driver's side).
2. Remove the front side trim. (Driver's side).
3. Partially peel back the floor covering.
4. Remove the bolts.
5. Disconnect the fuel-filler lid opener cable from the fuel-filler lid opener lever.
6. Install in the reverse order of removal.
Fuel Filler Lid Adjustment
1. Verify that the gap and height difference between the fuel-filler lid and
body.
2. Loosen the bolts and adjust the fuel-filler lid.
Standard clearance
a: 1.7—3.7 mm {0.07—0.14 ...
Fuel Filler Lid Opener Cable Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate (LH).
b. Front seat (LH).
c. Rear scuff plate.
d. B-pillar lower trim (LH).
e. Rear seat (4:2 ...
Other materials:
Wheel Hub, Steering Knuckle Inspection
Wheel Bearing Excessive Play Inspection
1. Install the magnetic base and dial gauge as shown in the figure and measure
the wheel bearing axial excessive play.
If it exceeds the maximum specification, replace the wheel hub bearing.
Front wheel bearing maximum play
0 ...
Jacking Positions, Vehicle Lift (2 Supports) And Safety Stand (Rigid Rack) Positions
Jacking Positions
WARNING:
Improperly jacking a vehicle is dangerous. The vehicle can slip off the jack
and cause serious injury. Use only the correct front and rear jacking points
and block the wheels.
CAUTION:
Use safety stands to support the vehicle after it has been ...
General Procedures (Brake)
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross
pattern to the following tightening torque.
Tightening torque
108—147 N·m {12—14 Kgf·m, 80—108 ft·lbf}
Brake Lines Disconnection
1. If any brake line has been ...
