Mazda CX-5 Service & Repair Manual: Front Tilt Motor Inspection
WARNING:
-
Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual before handling the front seat (side air bag integrated)..
CAUTION:
-
When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean cloth so as not to damage or soil the seat.
NOTE:
-
When removing the front seat from the vehicle or putting it back in, it can be performed smoothly by removing the headrest.
1. Disconnect the negative battery cable and wait for 1 min
..
2. Disconnect the front tilt motor connector.
3. Apply battery positive voltage to the front tilt motor terminals and inspect the front seat operation.
-
If not as specified, replace the front seat cushion frame.(See FRONT SEAT CUSHION FRAME REMOVAL/INSTALLATION.)
|
Front seat operation |
Connection |
|
|
B |
D |
|
|
Up |
GND |
B+ |
|
Down |
B+ |
GND |
Front Seat Side Cover Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings in the Workshop
Manual before handlin ...
Lift Motor Inspection
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual befor ...
Other materials:
Side Air Bag Sensor [Standard Deployment Control System]
Purpose
The side air bag sensor detects an impact during a lateral collision.
Function
The side air bag sensor converts the detected impact to an electrical signal.
Construction
The side air bag sensor is built into the crash sensor.
Two side air bag sensors ...
Fog Lights
Use this switch to turn on the fog lights.
The fog lights will improve visibility at night and during foggy conditions.
To turn the fog lights on, rotate the fog light switch to the
position.
The headlight switch must be in the
position before turning on the fog lights.
To turn the fog lig ...
Transfer Oil Seal Replacement [Fw6 Ax EL]
Transfer oil seal (LH)
1. Drain the transfer oil..
2. Remove the transfer from the vehicle..
3. Insert a tape-wrapped flathead screwdriver into the lip area of the oil seal
(LH) as shown in the figure and remove the oil seal (LH).
4. Using the SST and a hammer, tap the new seal into pla ...
