Mazda CX-5 Service & Repair Manual: Front Suspension
- Front Axle
- Front Lower Arm Inspection
- Front Lower Arm Removal/Installation
- Front Shock Absorber And Coil Spring Disassembly/Assembly
- Front Shock Absorber And Coil Spring Removal/Installation
- Front Shock Absorber Disposal
- Front Shock Absorber Inspection
- Front Stabilizer Control Link Inspection
- Front Stabilizer Removal/Installation
- Front Suspension
- Front Wheel Hub Bolt Replacement
- Wheel Hub, Steering Knuckle Inspection
- Wheel Hub, Steering Knuckle Removal/Installation
Wheel Hub Component Removal/Installation [Awd]
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Befo ...
Front Axle
Purpose, Function
An angular ball bearing, with a low rotational resistance, has been adopted,
improving driveability.
A unit bearing that does not require pre-load setting has bee ...
Other materials:
Tcs Off Switch, Tcs Off Indicator Light
Purpose/Function
The TCS OFF switch, located on the dashboard, allows for optionally enabling/disabling
the TCS control at driver discretion.
The TCS OFF indicator light, built into the instrument cluster, informs the
driver that TCS control has been disabled by operation ...
Forced Ignition On
NOTE:
In order to perform a forced ignition ON, the M-MDS is necessary. If the
servicing is being done outside of an Authorized Mazda dealership, contact an
Authorized Mazda dealership for instructions.
The forced ignition ON procedure forces a power supply to each part when
...
Auto Leveling Sensor Removal/Installation
1. Disconnect the negative battery cable..
2. Disconnect the connector.
3. Remove the bolts.
4. Remove the auto leveling sensor.
5. Install in the reverse order of removal.
6. Perform the auto leveling system initial setting.. ...
