1. Remove the front stabilizer control link..
2. Inspect for bending or damage. If there is any malfunction, replace the front stabilizer control link.
3. Rotate the front stabilizer control link ball joint stud 10 times
and shake it side to side 10 times
.
4. Measure the front stabilizer control link ball joint rotational torque using an Allen wrench and a torque wrench.
0.8—3.5 N·m {8.2—35 kgf·cm, 7.1—30 in·lbf}
If not within the specification, replace the front stabilizer control link.
Even if within specification, if there is excessive play in the front stabilizer control link ball joint, replace the front stabilizer control link.
Washer Fluid Level Sensor Removal/Installation
1. Disconnect the negative battery cable..
2. Set the front over fender aside..
3. Set the mudguard (RH) aside..
4. Remove the front bumper..
5. Disconnect the washer fluid-level sensor connector.
6. Remove the washer fluid-level sensor.
NOTE:
If the washer fluid-level sensor ...
Location of the Tire Label (Placard)
You will find the tire label containing tire inflation pressure by tire size
and other important information on the driver's side B-pillar or on the edge of
the driver's door frame.
SAMPLE
Recommended Tire Inflation Pressure
On the tire label you will find the recommended tire infla ...
Emission System
Purpose, Outline
A single-nano catalyst has been adopted for the under-floor, three-way catalyst
to improve emission gas purification efficiency.
Structural View
Engine compartment side
Exhaust system side
2WD
AWD
Fuel tank side
U.S.A. and CANADA (2WD)
U.S.A. a ...