Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Front Seat Adjuster Unit Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Seats / Front Seat Adjuster Unit Removal/Installation

WARNING:

CAUTION:

Driver-side (with power seat system)

1. Switch the ignition off (LOCK).

2. Disconnect the negative battery cable and wait for 1 min

..

3. Remove the following parts:

a. Front seat.

b. Front seat side cover.

c. Front buckle.

d. Seat track position sensor.

4. Remove fasteners A and set the front seat cushion trim aside.


5. Using a flathead screwdriver, disconnect the connector in the direction of the arrow (2) while releasing tab B in the direction of the arrow (1) shown in the figure.


6. Disconnect the slide motor connector.

7. Remove bolts A.


8. Remove the front seat adjuster unit.

9. Install in the reverse order of removal.

Driver-side (without power seat system)

1. Switch the ignition off (LOCK).

2. Disconnect the negative battery cable and wait for 1 min

..

3. Remove the following parts:

a. Front seat.

b. Front seat side cover.

c. Front buckle.

d. Seat track position sensor.

4. Slide hook A in the order of arrows (1), (2), (3) shown in the figure and set the front seat cushion trim aside.


5. Using a flathead screwdriver, disconnect the connector in the direction of the arrow (5) while releasing tab B in the direction of the arrow (4) shown in the figure.


6. Remove bolts A.


7. Install in the reverse order of removal.

Passenger-side

1. Switch the ignition off (LOCK).

2. Disconnect the negative battery cable and wait for 1 min

..

3. Remove the following parts:

a. Front seat.

b. Front seat side cover.

c. Front buckle.

d. Seat weight sensor control module.

4. Slide hook A in the order of arrows (1), (2), (3) shown in the figure and set the front seat cushion trim aside.


5. Disconnect the seat weight sensor control module connector.


6. Using a flathead screwdriver, disconnect the connector in the direction of the arrow (5) while releasing tab B in the direction of the arrow (4) shown in the figure.

7. Remove bolts A.


8. Install in the reverse order of removal.

Front Seat
Purpose, Function The front seats are structured to reduce impact force applied to the head of the occupant in a vehicle collision. 8WAY or 6WAY power seats have been adopted on the ...

Front Seat Back Component Removal/Installation
WARNING: Handling a side air bag improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings/cautions in the Workshop Manual befor ...

Other materials:

Antenna Feeder No.1 Inspection
With audio system 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. A-pillar trim (RH). b. Decoration panel. c. Audio unit. 3. Disconnect antenna feeder No.2. 4. Verify that the continuity between antenna feeder No.1 terminals is as indicated in the tabl ...

Rear Door Trim Removal/Installation
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow (1) in the figure and remove the inner handle cover while detach tabs A, pin B. 2. Remove the screw C. 3. Remove the cover D, then remove the screw E. 4. Take the shaded area shown in the figur ...

Magnetic Clutch Adjustment [Manual Air Conditioner]
1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge. 2. Verify the clearance. If not within the specification, remove the pressure plate and adjust the clearance by changing the shim (0.2 mm {0.008 i ...

© 2016-2022 Copyright www.mcx5.org