Mazda CX-5 Service & Repair Manual: Front Sash Molding Removal

Mazda CX-5 Service & Repair Manual / Body / Doors/Lids & Hood/Trunk / Front Sash Molding Removal

WARNING:

Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife.

1. Using a utility knife, carefully remove the double-sided adhesive tape in the locations shown below.

CAUTION:

When removing the double-sided adhesive tape, be careful not to damage clip A.

2. Insert a tape-wrapped flathead screwdriver shown in the figure and remove the protector in the direction of arrow (1).

3. Insert a tape-wrapped flathead screwdriver shown in the figure and remove clip A in the direction of arrow (2).

4. Remove the front sash molding in the direction of arrow in the order of (3), (4), (5) while detaching clip B.

5. Install in the reverse order of removal.

Front Sash Molding Installation

WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. NOTE: Double-sided adhesive tape has already been attached to t ...

Rear Door Trim Disassembly/Assembly

1. Disassemble in the order shown in the figure. 1 Switch panel cover 2 Power window subswitch. 3 Fastener ...

Other materials:

Rear Window Defroster
The rear window defroster clears frost, fog, and thin ice from the rear window. The ignition must be switched ON. Press the switch to turn on the rear window defroster. The rear window defroster operates for about 15 minutes and turns off automatically. The indicator light illuminates during op ...

Sail Garnish Removal/Installation
1. Open the front door. 2. Affix protective tape to the position shown in the figure. 3. Insert a tape-wrapped flathead screwdriver into the shown in the figure and remove the clip A in the direction of arrow (1). 4. Pull the sail garnish in the direction of the arrow (2) and remove it w ...

Liquid Crystal Display (LCD)
Outline The LCD displays vehicle information in the instrument cluster. The instrument cluster performs LCD fail-safe.. Function/Construction The instrument cluster configures the indication of the LCD based on the CAN signals sent from the related modules and displays ...