WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife.
NOTE:
Double-sided adhesive tape has already been attached to the new front sash molding.
1. When installing a new front sash molding, follow the procedure below:
a. Carefully remove the adhesive remaining on the body using a razor blade.
b. Remove any grease or dirt from the adhesion surface of the body.
2. Remove the adhesive remaining on the front sash molding and the body using a razor blade.
a. Remove any grease or dirt from the adhesion surface of the front sash molding and the body.
b. Apply primer to the bonding area of the front sash molding.
c. Affix double-sided adhesive tape to the front sash molding as shown in the figure.
NOTE:
As for the double-sided adhesive tape, use 3M GT7120 or equivalent.
3. Peel off the backing of the double-sided adhesive tape.
4. Hook tab A to the body in the position where clip B aligns with the sash holes.
5. Press the front sash molding in the direction of the arrow and install clip B to the body.
CAUTION:
Do not press the front sash molding in any place other than the rubber areas.
6. Press the front sash molding from the vehicle front in the direction of the arrow and install tab C.
7. Press the front sash molding in the direction of the arrow and install clip D to the body.
NOTE:
After installing the front sash molding, verify that tabs A and C are connected properly to the body.
Rear Side Panel Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
Throttle Body Inspection
Resistance Inspection
1. Disconnect the negative battery cable..
2. Disconnect the throttle body connector.
3. Measure the resistance between throttle body terminals E and F.
Throttle body resistance
1.38 ohms [20°C {68 °F}]
If not as specified, replace the throttle ...
Oil Control Valve (OCV) Inspection
Coil Resistance Inspection
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Disconnect the OCV connector.
4. Measure the resistance between terminals A and B using an ohmmeter.
OCV coil resistance
6.9—7.5 ohms [20°C {68°F}]
If not as ...