Symbol Mark
Removal Procedure
CAUTION:
Remove the curtain air bag module to prevent damage before servicing.
Front-side
Rear-side
CAUTION:
Avoid cutting with a blowtorch or similar tools as the insulator (shaded area) is flammable.
1. Rough cut the 2 locations indicated by (A) shown in the figure.
2. Drill the 82 locations indicated by (B) shown in the figure, then remove the cabin side outer frame (outer front pillar).
3. Rough cut area location indicated by (C) shown in the figure.
4. Drill the 7 locations indicated by (D) shown in the figure, then remove the front pillar reinforcement and front pillar inner reinforcement as a single unit.
NOTE:
When removing the front pillar reinforcement and the front pillar inner reinforcement separately, drill the 11 locations indicated by (E) shown in the figure.
5. Drill the 9 locations indicated by (F) shown in the figure, then remove the upper hinge reinforcement.
6. Drill the 4 locations indicated by (G) from the inside shown in the figure.
7. Drill the 11 locations indicated by (H) shown in the figure.
8. Drill the 1 location indicated by (I) shown in the figure, while peeling back the lower hinge reinforcement, then remove it.
9. Drill the 20 locations indicated by (J) shown in the figure, then remove the inner hinge pillar.
10. Rough cut the area location indicated by (K) shown in the figure.
11. Remove the inner front pillar.
Steering Switch Inspection
Without Bluetooth system
WARNING:
Handling the driver-side air bag module improperly can accidentally operate
(deploy) the air bag module, which may seriously injure you. Read the service
warnings and cautions before handling the air bag module..
1. Switch the ignition OFF (LOCK ...
Turn Light System
Purpose
The turn light system flashes the turn light three times automatically according
to the turn switch operation.
The front body control module (FBCM) performs turn light system fail-safe..
Function
The front body control module (FBCM) performs control based on th ...
Towing
Towing Description
Proper lifting and towing are necessary to prevent damage to the vehicle.
Government and local laws must be followed.
A towed vehicle usually should have its drive wheels (front wheels) off the
ground. If excessive damage or other conditions prevent this, use ...