Mazda CX-5 Service & Repair Manual: Front Fender Junction Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit properly.
4. Plug weld the 3 locations shown in the figure.
Electric Variable Valve Timing Relay [Skyactiv G 2.0]
Purpose, Function
The electric variable valve timing actuator relay supplies power to the electric
variable valve timing motor/driver after receiving the signal from the PCM.
Construct ...
Front Fender Junction Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 3 locations shown in the figure.
2. Remove the front fender junction. ...
Other materials:
Front Stabilizer Control Link Inspection
1. Remove the front stabilizer control link..
2. Inspect for bending or damage. If there is any malfunction, replace the front
stabilizer control link.
3. Rotate the front stabilizer control link ball joint stud 10 times and
shake it side to side 10 times.
4. Measure the front stabilizer c ...
Crankshaft Position (CKP) Sensor Removal/Installation
CAUTION:
When foreign material such as an iron chip is on the CKP sensor, it can cause
abnormal output from the sensor because of flux turbulence and adversely affect
the engine control. Be sure there is no foreign material on the CKP sensor when
replacing.
Do not assemble t ...
Valve, Valve Spring, Valve Seal, Valve Guide
Purpose, Function
Valve
The intake valve is pressed down by the cam, the intake air passage is opened,
and air is introduced into the cylinder.
The exhaust valve is pressed down by the cam, the exhaust air passage is
opened, and combustion gas is exhausted from the cylinder.
...