Mazda CX-5 Service & Repair Manual: Front Door Latch And Lock Actuator Inspection
-
The following actuator and switches are integrated with the front door latch and lock actuator.
-
From the actuator/switch name and operation in the following table, select the actuator or switch to be inspected, and perform the inspection following the inspection procedure described in the reference.
|
Actuator/Switch name |
Operation |
Reference |
|
Front door lock actuator |
Electrically switches the lock/unlock of the front doors. |
FRONT DOOR LOCK ACTUATOR INSPECTION |
|
Front door lock-link switch |
Turns on/off in conjunction with the lock/unlock so that the lock/unlock condition is detected. |
DOOR LOCK-LINK SWITCH INSPECTION |
|
Front door latch switch |
Turns on/off in conjunction with the latch lever operation so that the front door open/closed condition is detected. |
FRONT DOOR LATCH SWITCH INSPECTION |
|
Front key cylinder switch |
Turns on/off in conjunction with the lock/unlock of the front door key cylinder so that the key cylinder operation condition is detected. |
FRONT DOOR KEY CYLINDER SWITCH INSPECTION |
Front Door Key Cylinder Switch Inspection
1. Perform the front door glass preparation..
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Front door key cylinder.
d. ...
Front Door Latch And Lock Actuator Removal/Installation
1. Perform the front door glass preparation..
2. Disconnect the negative battery cable..
3. Remove the following parts:
a. Inner garnish.
b. Front door trim.
c. Inner handle.
d. Front door ...
Other materials:
Active Command Modes Inspection [Front Body Control Module (Fbcm)]
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization
screen of the M-MDS.
a. Select “DataLogger”.
b. Select “Modules”.
c. Select “F_BCM”.
3. Select the active command modes from the PID table.
4. Perform t ...
Front Wiring Harness Protector Removal/Installation
Front Wiring Harness Protector No.1
1. Disconnect the negative battery cable..
2. Remove the air cleaner case..
3. While pressing the tabs of clip A in the direction of the arrows (1) shown
in the figure, pull clip A in the direction of the arrow (2) shown in the figure
to detach the tab of ...
Oil Pressure Switch Inspection
1. Switch the ignition ON (engine off) and verify that the oil pressure warning
light is illuminated.
2. Start the engine and verify that the oil pressure warning light turns off.
If the oil pressure warning light is not illuminated or remains illuminated,
inspect the wiring harness ...
