Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Front Door Hinge Removal/Installation

Mazda CX-5 Service & Repair Manual / Body / Doors/Lids & Hood/Trunk / Front Door Hinge Removal/Installation

1. Disconnect the negative battery cable..

2. Remove the following parts:

a. Front bumper.

b. Front combination light.

c. Front bumper slider.

d. Front over fender.

e. Front fender panel.

f. Front door.

3. Remove in the order shown in the figure.



1

Bolt

2

Front door hinge


4. Install in the reverse order of removal.

Front Door Garnish Removal/Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. 1. Using a tape-wrapped fastener remover, remove clips A in the directi ...

Front Door Key Cylinder Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the service hole cover. 3. Detach the screw from the front door key cylinder. NOTE: The screw cannot be removed because the f ...

Other materials:

One Way Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The one-way clutch operates in 1GR and suppresses the counterclockwise rotation of the front internal gear (as viewed from torque converter side). Construction The one-way clutch consists of a mechanical diode-type one-way clutch, inner plate, and outer pla ...

Wiper/Washer System Personalization
A customize function has been adopted which switches the auto wiper system between operable/inoperable. Using Mazda Modular Diagnostic System (M-MDS) The auto wiper function can be enabled or disabled using the Mazda Modular Diagnostic System (M-MDS). Refer to the Workshop M ...

Cooling Fan Component
Purpose, Function The cooling fan rotates according to vehicle conditions and enhances the cooling efficiency of the radiator. Structural View Operation For the operation, refer to CONTROL SYSTEM.. Fail-safe Function not equipped. ...

© 2016-2022 Copyright www.mcx5.org