Mazda CX-5 Service & Repair Manual: Front Combination Light Disassembly/Assembly
1. Disassemble in the order shown in the figure.
Halogen type
|
1 |
Short cord (See Short Cord Removal Note.) |
|
2 |
Parking/Front turn light bulb (See PARKING/FRONT TURN LIGHT BULB REMOVAL/INSTALLATION.) |
|
3 |
Headlight LO bulb (See HEADLIGHT BULB REMOVAL/INSTALLATION.) |
|
4 |
Cover No.1 (See Cover Installation Note.) |
|
5 |
Headlight HI bulb (DRL (Daytime running light) bulb) (See HEADLIGHT BULB REMOVAL/INSTALLATION.) |
|
6 |
Cover No.2 (See Cover Installation Note.) |
Discharge type
|
1 |
Short cord (See Short Cord Removal Note.) |
|
2 |
Parking/Front turn light bulb (See PARKING/FRONT TURN LIGHT BULB REMOVAL/INSTALLATION.) |
|
3 |
Cover No.1 (See Cover Installation Note.) |
|
4 |
Igniter (See IGNITER REMOVAL/INSTALLATION.) |
|
5 |
Headlight HI/LO bulb (See HEADLIGHT BULB REMOVAL/INSTALLATION.) |
|
6 |
DRL (Daytime running light) bulb (See DRL (DAYTIME RUNNING LIGHT) BULB REMOVAL/INSTALLATION.) |
|
7 |
Cover No.2 (See Cover Installation Note.) |
|
8 |
Discharge headlight control module (See DISCHARGE HEADLIGHT CONTROL MODULE REMOVAL/INSTALLATION.) |
|
9 |
Seal |
2. Assemble in the reverse order of disassembly.
Short Cord Removal Note
1. While pressing the clip tab in the direction of the arrows (1) shown in the figure, press the clip in the direction of the arrow (2) shown in the figure to detach the clip tab and front combination light.
2. Remove the short cord.
Cover Installation Note
1. Install the cover to the housing so that there is no clearance between the housing and the cover.
CAUTION:
-
If there is a gap between the housing and the cover, water may penetrate from the gap causing a malfunction in the front combination light. Verify that there is no gap between the cover and the housing.
Front Combination Light
Purpose
Parts related to the front exterior lights are grouped and housed together
such as the headlight, front turn/parking light, headlight leveling actuator,
wiring harnesses, and conn ...
Front Combination Light Removal/Installation
WARNING:
Incorrect servicing of the discharge headlights could result in electrical
shock. Before servicing the discharge headlights, always refer to the service
warnings..
NOTE:
...
Other materials:
Clock Spring Adjustment [Two Step Deployment Control System]
1. Set the front wheels straight ahead.
CAUTION:
The clock spring will break if over?wound. Do not forcibly turn the clock
spring.
2. Turn the clock spring clockwise until it stops.
3. Turn the clock spring counterclockwise approx. 2 turns.
4. Align the mark on the clo ...
Rear Door Trim Disassembly/Assembly
1. Disassemble in the order shown in the figure.
1
Switch panel cover
2
Power window subswitch.
3
Fastener
4
Rear door trim
2. Assemble in the reverse order of disassembly.
...
Side Member Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 45 locations shown in the figure.
NOTE:
When drilling, do not drill a hole all the way through or there could be
a problem when installing the new part.
2. Remove the side member. ...
