Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Front Body Straight Line Dimensions (1) [Dimensions]

Mazda CX-5 Service & Repair Manual / Body / Body Exterior, Frame / Frame / Front Body Straight Line Dimensions (1) [Dimensions]




Point symbol

Designation

Hole diameter or bolt or nut size mm {in}

A

Cowl panel installation hole

?5 {0.2}

B

Wiper bracket datum hole

?7 {0.3}

C

Hood hinge installation hole

?10 {0.39}

D

Front suspension upper mounting installation hole

?10.2 {0.402}

E

Front fender panel installation hole

?7 {0.3}

F

Apron reinforcement lower datum hole

?10 {0.39}

G

Shroud upper member installation hole

?7 {0.3}


Dumping Sheet Replacement [Water Proof And Rust Preventive]
After repairing the body, attach the dumping sheet to the location shown in the figure for noise insulation. ...

Front Body Straight Line Dimensions (2) [Dimensions]
Point symbol Designation Hole diameter or bolt or nut size mm {in} A Roof seamless location - ...

Other materials:

High Pressure Fuel Pump Inspection
NOTE: The following vacuum values are indicated by relative pressure from the fuel pressure sensor. 1. Verify that the fuel pressure sensor is normal.. 2. Connect the M-MDS to the DLC-2. 3. Switch the ignition ON (engine off). 4. Select the “FUEL_PRES”, “LOAD” and “R ...

Resistor Removal/Installation [Manual Air Conditioner]
NOTE: When removing the resistor, perform the procedure in the posture shown in the figure. 1. Disconnect the negative battery cable.. 2. Remove the dashboard under cover.. 3. Disconnect the connector. 4. Rotate the resistor (2) while pressing the tab (1). 5. R ...

Drive By Wire Control
Outline Calculates the optimum target throttle valve opening angle at all engine speeds and controls the throttle valve actuator. The drive-by-wire control is composed of the idle air control, accelerator control, traction control, excess engine speed control, overspeed control, ...

© 2016-2024 Copyright www.mcx5.org