Mazda CX-5 Service & Repair Manual: Front Axle Assembly

Rear Drive Shaft Removal/Installation

CAUTION: Performing the following procedures without first removing the ABS wheel?speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before perfor ...

Front Axle

Purpose, Function An angular ball bearing, with a low rotational resistance, has been adopted, improving driveability. A unit bearing that does not require pre-load setting has been ...

Other materials:

Disc Pad (Rear) Replacement
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, pump the brake pedal a few times and inspect the following: The disc pad projection is securely installed to the piston groove Parking brake lever stroke Bra ...

Tire Pressure Monitoring System
Tire Pressure Monitoring System • The Tire Pressure Monitoring System (TPMS) monitors the air pressure of all four wheels. If the air pressure of one or more tires is too low, the system warns the driver by indicating the tire pressure monitoring system warning light in the instrument clust ...

Front Accessory Socket Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Insert a tape-wrapped flathead screwdriver into the gap between the cap tab and socket. 4. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, press the front accessory socket i ...