Mazda CX-5 Service & Repair Manual: Frame
- Body Sealing [Water Proof And Rust Preventive]
- Cabin Side Frame Straight Line Dimensions [Dimensions]
- Center Pillar Installation [Panel Replacement]
- Center Pillar Removal [Panel Replacement]
- Construction Standard Values [Construction Standard Values]
- Corner Plate Installation [Panel Replacement]
- Corner Plate Removal [Panel Replacement]
- Dumping Sheet Replacement [Water Proof And Rust Preventive]
- Front Body Straight Line Dimensions (1) [Dimensions]
- Front Body Straight Line Dimensions (2) [Dimensions]
- Front Crossmember Removal/Installation
- Front Frame (Rear) Installation [Panel Replacement]
- Front Frame (Rear) Removal [Panel Replacement]
- Front Pillar Installation [Panel Replacement]
- Front Pillar Removal [Panel Replacement]
- Front Seat Cushion Frame Removal/Installation
- Front Side Frame (Partial Cutting) Installation [Panel Replacement]
- Front Side Frame (Partial Cutting) Removal [Panel Replacement]
- Front Side Frame Installation [Panel Replacement]
- Front Side Frame Removal [Panel Replacement]
- Rear Body Straight Line Dimensions (1) [Dimensions]
- Rear Crossmember Removal/Installation [2 Wd]
- Rear Crossmember Removal/Installation [Awd]
- Rear Pillar (Outer) Installation [Panel Replacement]
- Rear Pillar (Outer) Removal [Panel Replacement]
- Rear Seat Back Frame Removal/Installation
- Rear Side Frame Installation [Panel Replacement]
- Rear Side Frame Removal [Panel Replacement]
- Room Straight Line Dimensions (1) [Dimensions]
- Room Straight Line Dimensions (2) [Dimensions]
- Room Straight Line Dimensions (3) [Dimensions]
- Rust Preventive Treatment [Water Proof And Rust Preventive]
- Side Member Installation [Panel Replacement]
- Side Member Removal [Panel Replacement]
- Torque Box Installation [Panel Replacement]
- Torque Box Removal [Panel Replacement]
- Ultra High Tension Steel [Construction]
- Under Coating [Water Proof And Rust Preventive]
Ventilator Grille Removal/Installation
Side Ventilator Grille
Driver-side
1. Disconnect the negative battery cable..
2. Remove the switch panel..
3. Insert your hand from the area where the switch panel was installed, remove
the si ...
Body Sealing [Water Proof And Rust Preventive]
Sealant is applied to the parts where the panels meet and to the hemmed parts
of the door panel and hood panel to provide water proofing and rust proofing.
...
Other materials:
Knock Sensor (Ks)
Purpose/Function
Detects abnormal combustion in the cylinder as basic information for mainly
determining the ignition timing.
Detects abnormal combustion in the combustion chamber and inputs it to the
PCM as a knocking signal.
Construction
Installed on the cylinder ...
Main Relay Control [Skyactiv G 2.0]
Outline
Supplies power to each part by switching the main relay on/off at the optimal
timing according to the vehicle conditions.
Block Diagram
Operation
When the ignition is switched ON, the main relay turns on and electrical
power is supplied to each sensor and devic ...
Condenser Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim (LH).
c. Rear scuff plate (LH).
d. Trunk side trim (LH).
e. D-pillar trim (LH).
3. Disconnect the connector.
4. Remove the bolts.
5. Remove the condenser.
6. Install in ...
