Mazda CX-5 Service & Repair Manual: Flywheel Inspection [C66 M R]
1. Remove the flywheel..
2. Perform the following procedures to inspect the flywheel.
-
If there is any malfunction or it exceeds the maximum specification, replace the flywheel..
a. Inspect the surface that contacts the clutch disc for scratches, nicks, and discoloration.
-
Correct slight scratches and discoloration using sandpaper.
b. Inspect the ring gear teeth for damage and wear.
c. Inspect the runout of the surface that contacts the clutch disc.
i. Install the flywheel..
ii. Measure the runout of the surface that contacts the clutch disc using a dial gauge.
-
Flywheel maximum runout
-
0.1 mm {0.004 in}
Clutch [C66 M R]
Purpose, Function
The clutch unit transmits or cuts the drive force between the engine and
MTX according to the clutch pedal operation.
Construction/Operation
The construction/o ...
Low Clutch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The low clutch operates in 1GR, 2GR, 3GR and 4GR and intermittently operates
the sun gear by drive force from the turbine shaft.
For the low clutch, a centrifugal ba ...
Other materials:
Vent Operation
Adjusting the Vents
Directing airflow
To adjust the direction of airflow, move the adjustment knob.
NOTE
hen using the air conditioner under humid ambient temperature conditions,
the system may blow fog from the vents. This is not a sign of trouble but a result
of humid air being suddenly co ...
Electric Variable Valve Timing Motor/Driver Removal/Installation
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
CAUTION:
Applying excessive force (force of 100 N {10.2 kgf, 22.5 lbf} or more) to
the electric variable valve timing motor/driver may cause a malfunction. When
...
Front Body Straight Line Dimensions (1) [Dimensions]
Point symbol
Designation
Hole diameter or bolt or nut size mm {in}
A
Cowl panel installation hole
?5 {0.2}
B
Wiper bracket datum hole
?7 {0.3}
C
...
