Mazda CX-5 Service & Repair Manual: Floor Covering Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Front side trim.
c. Rear scuff plate.
d. B-pillar lower trim.
e. Rear seat cushion.
f. Front seat.
g. Lower anchor of the front seat belt (without lap pre-tensioner seat belt).
h. Lap pre-tensioner seat belt (with lap pre-tensioner seat belt).
i. Shift lever knob (MTX).
j. Front console box.
k. Shift panel.
l. Upper panel.
m. Rear console.
n. Side wall.
o. Front console.
p. SAS control module.
q. Parking brake lever.
r. Joint cover.
3. Remove fasteners.
4. Take the floor covering out from the opened door.
5. Install in the reverse order of removal.
Decoration Panel Removal/Installation
CAUTION:
Affix protective tape to the position shown in the figure.
1. Disconnect the negative battery cable..
2. Open the glove compartment.
3. Insert a tape-wrapped flathead ...
Floor Insulator Removal/Installation
Driver-side
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Driver-side front scuff plate.
b. Driver-side front side trim.
c. Decoration panel.
d. Shift lever k ...
Other materials:
Audio System
NOTE:
“iPod” is a registered trademark of Apple Inc. in the United States and other
countries.
Outline
An audio unit compatible with AM/FM tuner and MP3/WMA (Windows Media Audio)/AAC
(Advanced Audio Coding) has been adopted.
There are two types of audio units, ...
Windshield Wiper Arm And Blade Removal/Installation
Windshield Wiper Arm
1. Open the hood.
CAUTION:
If excessive force is applied when removing the cap, tabs could break. Carefully
remove the cap.
2. Insert a tape-wrapped precision flathead screwdriver into the gap between
the windshield wiper arm and cap, and slightly raise the ...
Restraints
Abbreviations
AAS
Active Adaptive Shift
ABS
Antilock Brake System
ABDC
After Bottom Dead Center
ACC
Accessories
AFS
Adaptive Front Lighting System
...
