Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Filament Inspection

1. Switch the ignition ON (engine off).

2. Turn the rear window defroster switch on.


CAUTION:

3. Connect the positive lead of the tester to the positive side of each filament and the negative lead to ground.

4. Gradually slide the positive lead from the positive side to the negative side and verify that the voltage decreases accordingly.



Measured part

Voltage (Reference)

(1) to (2)

Approx. 11 V to 0 V


Auto Dimming Mirror Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the screw B. 3. Remove the auto-dimming mirror in the direction of arrow (1) shown in the figure. 4. Detach tabs while push the cov ...

Filament Repair
1. Clean the filament using isopropyl alcohol. 2. Attach tape to both sides of the filament. 3. Using a small brush or marking pen, apply silver paint. 4. After 2—3 min, carefully remove t ...

Other materials:

Clock Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Shift lever knob (MTX). b. Front console box. c. Shift panel. d. Upper panel. e. Rear console. f. Side wall. g. Decoration panel. h. Front console. i. Glove compartment. j. Climate control unit. 3. C ...

Differential Oil Temperature Sensor Inspection
WARNING: Hot differential oil may cause severe burns. Do not perform maintenance while differential oil is hot. 1. Disconnect the negative battery cable. 2. Disconnect the differential oil temperature sensor connector and remove the differential oil temperature sensor. 3. Wrap ...

Identification Number Locations
Vehicle Identification Number (VIN) If the VIN plate is adhered to the dashboard, it is located in the position shown in the figure. Engine Type/Number SKYACTIV-G 2.0 SKYACTIV-G 2.5 ...

© 2016-2024 Copyright www.mcx5.org