Mazda CX-5 Service & Repair Manual: Exterior

Light Switch Removal/Installation

NOTE: When removing the light switch, it is necessary to rotate the steering wheel. If the ignition is switched off from ON (engine on) with the driver's door closed, the steering wh ...

Adaptive Front Lighting System (Afs) Control Module Removal/Installation

NOTE: The AFS control module prior to replacement stores the vehicle specification information. A new AFS control module does not store any vehicle specification information. ...

Other materials:

Anticorrosion, Sound Insulation, And Vibration Insulation
Body Sealing Apply body sealer where necessary. For locations where application of body sealer is difficult after installation, apply it before installation. Application of Undercoating Apply an undercoat to the required location of the body. Application ...

Lower Panel Removal/Installation
Driver-side 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear ...

Front Fender Panel Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front bumper. b. Front combination light. c. Front bumper slider. d. Front over fender. 3. Remove bolts A and fasteners B. 4. Remove bolts C. 5. Remove the front fender panel. 6. Install in the reverse ...