Mazda CX-5 Service & Repair Manual: Entertainment System
Outline
-
The following entertainment system has been adopted.
-
Audio system (with audio system)
-
Car-navigation system (with car-navigation system)
-
Park assist system (with park assist system)
-
Bluetooth system (with Bluetooth system)
-
An audio unit with integrated AM/FM tuner/MP3/WMA (Windows Media Audio)/AAC (Advanced Audio Coding) applicable CD player in the audio panel.
-
Steering switch has been adopted.
-
A SIRIUS satellite radio antenna which can receive SIRIUS satellite radio has been adopted. (with SIRIUS satellite radio unit)
-
Auxiliary jack/USB port has been adopted.
-
A center roof antenna has been adopted.
-
A glass antenna has been adopted.
-
A rear mount camera has been adopted.
Structural view
D Pillar Speaker Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
e. D-pillar trim.
3. Disconnect the ...
Front Center Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the center speaker grille..
3. Remove the front center speaker..
4. Verify that the resistance between the front center speaker terminals is ...
Other materials:
Blower Unit
Purpose
The blower unit switches between fresh air and recirculated air (FRESH/REC)
and sends airflow into the cabin.
Function
Air is blown by the blower motor in the blower unit.
The blower unit switches the air intake port to FRESH or REC based on the
position of ...
Automatic Transaxle Outline [Fw6 A EL, Fw6 Ax EL]
Outline
Contribution to low fuel economy
Wide TCC range
Clutch/brake resistance reduction
Realized direct feel and quick shifting
Oil passage resistance reduction and improved clutch/brake response
b ...
Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor
No.2 Removal/Installation
NOTE:
Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the
IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2.
1. Disconnect the negative battery cable..
2. Disconnect the MAP sensor/IAT sensor No.2 connector.
3. Remove the MAP sensor/IA ...
