Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Engine Oil Solenoid Valve Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Lubrication / Engine Oil Solenoid Valve Removal/Installation

WARNING:

1. Disconnect the negative battery cable..

2. Remove the front under cover No.2..

3. Remove the splash shield (RH)..

4. Remove in the order indicated in the table.

5. Install in the reverse order of removal.

6. Start the engine and confirm that there is no oil leakage.



1

Engine oil solenoid valve connector

2

Oil pressure switch connector

3

Oil pressure switch

(See Oil Pressure Switch Installation Note.)

4

Engine oil solenoid valve

(See Engine Oil Solenoid Valve Removal Note.)

(See Engine Oil Solenoid Valve Installation Note.)

5

Gasket


Engine Oil Solenoid Valve Removal Note

1. Cover the area around the engine oil solenoid valve with a rag because a small amount of engine oil will leak from the engine oil solenoid valve installation area.

CAUTION:

Engine Oil Solenoid Valve Installation Note

1. After tightening the three bolts shown in the figure, tighten the first tightened bolt to the specified tightening torque again.


NOTE:

Oil Pressure Switch Installation Note

CAUTION:

1. Apply silicone sealant to the oil pressure switch threads as shown in the figure.


CAUTION:

2. Install the oil pressure switch.

Engine Oil Solenoid Valve Inspection
Engine Oil Solenoid Valve Operation Inspection 1. Remove the engine oil solenoid valve.. 2. Verify that the battery is fully charged. 3. Connect the battery to the engine oil solenoid valve conne ...

Engine Oil Solenoid Valve
Purpose, Function The engine oil solenoid valve switches the hydraulic transmission passage in accordance with the driving conditions and the oil pump drive resistance is reduced by contr ...

Other materials:

Wheel Hub Component Removal/Installation [2 Wd]
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (body sid ...

Ignition Switch
Push Button Start Positions The system operates only when the driver is in the vehicle or within operational range while the key is being carried. Each time the push button start is pressed, the ignition switches in the order of off, ACC, and ON. Pressing the push button start again from ON sw ...

Rear Window Defroster/Outer Mirror Heater
Outline Fogging is cleared from the rear window and outer mirror glass by heating of the filament. Structural view System wiring diagram Vehicles with full-auto air conditioner system Vehicles with manual air conditioner system Construction Rear window defroster ...

© 2016-2022 Copyright www.mcx5.org