Mazda CX-5 Service & Repair Manual: Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING:
-
When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Drain the engine coolant..
4. Pull out the evaporative hose No.1 from the catch tank and set it aside.
5. Pull out the ventilation hose from the air hose and set it aside.
6. Remove the clip and loosen the wiring harness.
7. Disconnect the ECT sensor No.1 connector.
8. Remove the ECT sensor No.1 using the SST
.
9. Install in the reverse order of removal.
10. Refill the engine coolant..
ECT Sensor No.2
1. Disconnect the negative battery cable..
2. Drain the engine coolant..
3. Lift up the bracket.
4. Disconnect the ECT sensor No.2 connector.
5. Remove the ECT sensor No.2 from the water pipe.
6. Install in the reverse order of removal.
7. Refill the engine coolant..
Engine Coolant Temperature (ECT) Sensor Inspection
Resistance Inspection
WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until
it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Remove the ...
Engine Coolant Temperature (ECT) Sensor
Purpose/Function
Detects the ECT as basic information for mainly determining the fuel injection
amount.
Detects the ECT and inputs it to the PCM as an ECT signal.
The ECT sen ...
Other materials:
Manual Transaxle Oil Inspection [C66 M R]
1. Park the vehicle on level ground.
2. Remove the front under cover No.2..
3. Remove the oil level plug and gasket.
4. Verify that the manual transaxle oil is near the brim of the plug port.
When the manual transaxle oil level is lower than the lower limit, add manual
transaxl ...
Brake System/ABS Warning Light
Purpose/Function
The brake system/ABS warning light is built into the instrument cluster.
If a malfunction is detected in the system with the parking brake released,
the warning light illuminates to notify the driver.
Construction/Operation
When the DSC system and CAN l ...
Rear Wheel Hub Bolt Replacement
1. Remove the brake calliper component and suspend it out of the way using a
cable.
2. Remove the disc plate.
3. Remove the wheel hub bolt using the SST as shown in the figure.
4. Place a new wheel hub bolt in the wheel hub.
5. Install the wheel hub by placing a proper sized washer o ...
