Mazda CX-5 Service & Repair Manual: Engine Coolant Temperature (ECT) Sensor Inspection
Resistance Inspection
WARNING:
-
When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Remove the ECT sensor No.1..
2. Place the ECT sensor No.1 in water with a thermometer, and heat the water gradually.
3. Measure the resistance between ECT sensor No.1 terminals A and B.
-
If not as specified, replace the ECT sensor No.1..
|
ECT (°C {°F}) |
Resistance (Kilohms) |
|
20 {68} |
Approx. 2.45 |
|
80 {176} |
Approx. 0.318 |
ECT Sensor No.2
1. Remove the ECT sensor No.2..
2. Place the ECT sensor No.2 in water with a thermometer, and heat the water gradually.
3. Measure the resistance between ECT sensor No.2 terminals A and B.
-
If not as specified, replace the ECT sensor No.2..
|
ECT (°C {°F}) |
Resistance (Kilohms) |
|
20 {68} |
Approx. 2.45 |
|
80 {176} |
Approx. 0.318 |
Crankshaft Position (CKP) Sensor
Purpose/Function
Detects the crankshaft speed as basic information for mainly determining
the fuel injection timing and ignition timing.
Detects the crankshaft speed and inputs it to ...
Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until
it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Disconnect the negative battery c ...
Other materials:
Rear Drive Shaft Inspection
1. Inspect each connecting part for looseness.
Tighten or replace parts if necessary.
2. Inspect the dust boot on the drive shaft for cracks, damage, leaking grease,
and looseness in the boot band.
3. Inspect the drive shaft for bends, cracks, and wear in the joints or splines. ...
Crankshaft Position (CKP) Sensor
Purpose/Function
Detects the crankshaft speed as basic information for mainly determining
the fuel injection timing and ignition timing.
Detects the crankshaft speed and inputs it to the PCM as a CKP signal.
Construction
Installed on the side of the cylinder block (ri ...
Fuel Pump Control Module Inspection
1. Perform the KOEO self-test..
2. Verify that a fuel pump control module related DTC is detected..
If DTCs are detected, repair the malfunctioning part according to the applicable
DTC troubleshooting..
If a DTC is not detected, go to the next step.
3. Inspect the followin ...
