Mazda CX-5 Service & Repair Manual: Engine Coolant Temperature (ECT) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Cooling / Engine Coolant Temperature (ECT) Sensor

Purpose/Function

Detects the ECT as basic information for mainly determining the fuel injection amount.
Detects the ECT and inputs it to the PCM as an ECT signal.
The ECT sensor No.2 is only used for OBD.

Construction

ECT sensor No.1

Installed to the water outlet case.
A thermistor has been adopted as the detecting element for detecting the ECT.

ECT sensor No.2

Installed on the water pipe.
A thermistor has been adopted as the detecting element for detecting the ECT.

Operation

Inputs the signal, which fluctuates according to the ECT, to the PCM.

ECT sensor characteristic

Fail-safe

ECT sensor No.1


DTC No.	Fail-safe function
P0117:00	Fixes the water temperature for the engine control at 40 °C {104 °F}, and for the idle air control at 80 °C {176 °F}. Operates the cooling fan (high speed rotation). Inhibits the fuel cut control during shift change.
P0118:00	Fixes the water temperature for the engine control at 40 °C {104 °F}, and for the idle air control at 80 °C {176 °F}. Operates the cooling fan (high speed rotation). Inhibits the fuel cut control during shift change.

ECT sensor No.2

Function not equipped.

Engine Coolant Temperature (ECT) Sensor Removal/Installation

WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Disconnect the negative battery c ...

Fan Switch Inspection [Manual Air Conditioner]

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Shift lever knob (MTX). b. Glove compartment. c. Front console box. d. Shift panel. e. Upper panel. f. Rear c ...

Other materials:

Fully Automatic Type
Climate control information is displayed on the display. Control Switches AUTO switch By pressing the AUTO switch the following functions will be automatically controlled in accordance with the selected set temperature: • Airflow temperature • Amount of airflow • Selection of airflow ...

Starter Relay [Skyactiv G 2.0]
Purpose, Function The starter relay supplies power to the starter by receiving the signal from the PCM. Construction The starter relay is installed to the relay and fuse block. Operation The contact point is on when the voltage is supplied to the coil based on ...

Air Intake Actuator Inspection [Full Auto Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. If the operation condition is not normal, replace the air intake actuator. ...