Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Electric Power Steering System

Mazda CX-5 Service & Repair Manual / Steering / Linkage, Power / Electric Power Steering System

Outline

Structural View


System Wiring Diagram


Purpose/Function

Construction

Operation

1. Steering force generated by the driver's steering wheel operation is detected by the torque sensor which is built in the steering column and shaft, and is output to the EPS CM as a steering torque signal.

2. The EPS CM calculates optimum assist force based on the steering torque signal from the torque sensor and the vehicle speed and engine speed signals from the PCM, and outputs electric current to drive the EPS motor.

3. The EPS motor is driven by the current from the EPS CM and the force is transmitted to the intermediate shaft via the reduction gears, thus assisting steering operation of the driver.


Electric Power Steering (Eps) Motor
Purpose, Function The EPS motor is driven by the control current from the EPS CM (control module) and generates assist torque to manual steering mechanism. Construction The EPS ...

Eps Control Module Inspection
1. Remove the driver-side front scuff plate.. 2. Remove the driver-side front side trim.. 3. Remove the car-navigation unit (with car-navigation system).. 4. Remove the switch panel.. 5. Remov ...

Other materials:

Blind Spot Monitoring (Bsm) Control Module Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the rear bumper.. 4. Disconnect the connector. 5. Remove the nuts. 6. Remove the BSM control module. 7. Install in the reverse order of removal. 8. Perform the BSM radar test.. CAUTION: ...

Immobilizer System
The immobilizer system allows the engine to start only with a key the system recognizes. If someone attempts to start the engine with an unrecognized key, the engine will not start, thereby helping to prevent the theft of your vehicle. If you have a problem with the immobilizer system or the k ...

Front Door Latch And Lock Actuator Removal/Installation
1. Perform the front door glass preparation.. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inner garnish. b. Front door trim. c. Inner handle. d. Front door glass. e. Front door module panel. f. Front door key cylinder. 4. Remove the door lock knob c ...

© 2016-2024 Copyright www.mcx5.org