Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: DSC Related Parts Sensor Initialization Procedure

Mazda CX-5 Service & Repair Manual / Brakes / Brake Control, Vehicle Dynamics / General Information / DSC Related Parts Sensor Initialization Procedure

WARNING:

1. Inspect the wheel alignment and the tire pressure.

2. Position the vehicle on level ground.

3. Switch the ignition to off.

4. Connect the M-MDS (IDS) to DLC-2.

5. After the vehicle is identified, select the following items from the initial screen of the IDS.

6. Then, select an item from the screen menu.

7. Perform the procedure according to the directions on the screen.

8. Drive the vehicle.

9. After 5 min or more

of driving, verify that the DSC system is normal.

DSC HU/CM Removal/Installation
WARNING: If the DSC HU/CM configuration is not completed, it could result in an unexpected accident due to the DSC being inoperative. If the DSC HU/CM is replaced, always use the automat ...

Dynamic Stability Control (DSC)
Outline Electrical brake assist control has been adopted, improving safety. The DSC HU/CM, integrating both the hydraulic unit (HU) and control module (CM), has been adopted, resulti ...

Other materials:

Rear Stabilizer Removal/Installation [2 Wd]
WARNING: Verify that the rear crossmember is securely supported by a jack. If the rear crossmember falls off, it can cause serious injury or death, and damage to the vehicle. CAUTION: Performing the following procedures without first removing the rear ABS wheel-spee ...

Camshaft Position (CMP) Sensor Removal/Installation
CAUTION: When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfunction resulting from fluctuation in magnetic flux and cause a deterioration in engine control. ...

Rear Shock Absorber Disposal
WARNING: Whenever drilling into a rear shock absorber, wear protective eye wear. The gas in the rear shock absorber is pressurized, and could spray metal chips into the eyes and face when drilling. 1. Clamp a rear shock absorber on a flat surface or with the piston pointing ...

© 2016-2022 Copyright www.mcx5.org